MOTOKIYAS.

Motorcycles › Compare

CFMoto 250NK vs Honda Forza 250

ESTIMATED SIMULATION

Run the comparison →

The CFMoto 250NK (2026) and the Honda Forza 250 (2026) are compared with the same Moto Kıyas physics model under identical conditions: flat dry asphalt, no wind, a 75 kg rider and no passenger. The CFMoto 250NK is a naked bike with 249 cc, 26.2 hp and unlisted weight; the Honda Forza 250 is a scooter with 249 cc, 22.8 hp and 186 kg. Power-to-weight with the rider: 111.2 hp/ton versus 87.4 hp/ton. On this measure the CFMoto 250NK is 27% ahead.

In the simulation the CFMoto 250NK covers 0-100 km/h (speedometer) in 8.91 s and the Honda Forza 250 in 10.05 s; the CFMoto 250NK is quicker by 1.15 s. In the 100-0 km/h brake test, braking distance without the 0.3 s reaction time is 48.0 m for the CFMoto 250NK (ABS unknown, class assumption: no ABS) and 45.2 m for the Honda Forza 250 (with ABS). The Honda Forza 250 stops 2.8 m shorter. Calculated top speed: 115 km/h (estimated from power and drag) versus 124 km/h (GPS measurement).

All values are an estimated simulation, not road-test measurements. Technical data comes from the sources listed below; the model uses model-specific parameters calibrated against published road tests for both. Open the interactive app (currently in Turkish) to watch the run side by side and change the load.

Estimated simulationCFMoto 250NKHonda Forza 250
Classnaked bikescooter
Engine249 cc249 cc
Power26.2 hp22.8 hp
Wet weightno data186 kg
Power-to-weight (75 kg rider)111.2 hp/ton87.4 hp/ton
0-100 km/h (speedometer)8.91 s10.05 s
100-0 km/h braking distance48.0 m45.2 m
Top speed (calc.)115 km/h124 km/h

Data sources and calibration

Specifications: the sources below (manufacturer pages, plus road-test or spec sites where the manufacturer gives no figure). Acceleration, braking and top speed: Moto Kıyas physics simulation (power/torque curve, gearing, drag, traction and wheelie limits, ABS assumption), calibrated against published road tests where available. Estimated, not measured.

More comparisons